Skip to content

Badge Edition. Expansion module

Linar Yusupov edited this page Feb 23, 2024 · 9 revisions

There are two types of the expansion module available.
The first one is a bare-bone pin-to-pin cable. The second one is populated with MPU-9250 IMU sensor and MSM261 MEMS microphone.

The module occupies a miniature slot on the T-Echo main board.

Just plug it in like that and you are all set.

Certain pads of the cable have direct match to pinout of most I2C sensors on the market. One can use it to connect a BMP280 air pressure sensor (if your T-Echo variant does not have it built-in)

When a sensor is connected properly - it gets detected at boot time.


ATTENTION: the basic IMU support is a part of Release 1.2 firmware update.


The data from air pressure and/or IMU sensors gets displayed on the Baro and G load UI pages respectively.



There is an option to connect an external RS-232C device to UART pins of the T-Echo MCU.

Function Pin
TxD P0.06
RxD P0.08


Signal levels: 3.3 Volt
Transfer settings: 38400 bps, 8N1


Use the SoftRF Configuration Tool then to alter direction of data output.


Bill of materials

Number Part Qty Picture Source
1 LilyGO®
T-Echo  Expansion module
1 AliExpress
2 Bosch BMP280
pressure
sensor
1 AliExpress

Hardware

SoftRF

SkyView

Flight Recorder

Adapters

Software

Firmware

Tools

Protocols

Clone this wiki locally