Compaq 5000 Series End-User Replaceable Parts Program
  1. Manuals
  2. Brands
  3. Compaq Manuals
  4. Desktop
  5. 5000 Series
  6. End-user replaceable parts program
Compaq 5000 Series End-User Replaceable Parts Program

Compaq 5000 Series End-User Replaceable Parts Program

Replacing the dvd-ram drive
Hide thumbs Also See for 5000 Series:
Table of Contents

Advertisement

Quick Links

Download this manual
Replacing the DVD-RAM Drive
5000 and 7000 Series
End-User Replaceable Parts Program

Advertisement

Table of Contents
loading

Related Manuals for Compaq 5000 Series

Summary of Contents for Compaq 5000 Series

  • Page 1 Replacing the DVD-RAM Drive 5000 and 7000 Series End-User Replaceable Parts Program...
  • Page 3 All other product names mentioned herein may be trademarks or registered trademarks of their respective companies. Compaq shall not be liable for technical or editorial errors or omissions contained herein. The information in this document is subject to change without notice.

  • Page 4: Dvd-Ram Drive

    Replacing the Introduction DVD-RAM Drive Your Compaq Internet PC has an Easy Access panel that makes accessing the internal parts easy. The DVD-RAM drive This document describes how to remove and replace the allows you to view what DVD-RAM drive (see Figure 1-1).

  • Page 5: Tools Needed

    Compaq. Your replacement part is warranted for the longer of 90 days from the date the part was delivered to you, or the original One Year Limited Warranty that came with your Compaq Presario. Preparing Your Computer for Disassembly...

  • Page 6: Disconnecting The Power

    I. Disconnecting the Power 1. To shut down your computer, click the Start button, and then click Shut Down. The Shut Down Windows dialog box is displayed. Click OK to turn the computer off. 2. Disconnect the power cord from the electrical outlet 1 and 2 computer (see Figure 1-2).
  • Page 7 II. Opening the Side Access Panel 1. Remove the screw 1 securing the side access panel. Locate the latch 2 directly below the screw, press the latch down, and hold it in the down position (Figure 2-1). Did you know ... You do not have to replace the screw securing the side access panel.
  • Page 8 III. Removing the Upper Front Panel and CD Storage Door (Lower Front Panel) 1. Locate the front panel door lock inside the chassis. The lock is located on the base of the lower 3.5 inch diskette drive cage inside the chassis (see Figure 3-1). 2.
  • Page 9 3. On the front of the system, press the indentation 1 located on the CD Storage door (lower front panel) to open the lower door 2 (see Figure 3-2). Figure 3-2 DVD-RAM D EPLACING THE RIVE...
  • Page 10 4. Locate the finger holes 1 under the bottom of the upper front panel and place your fingers in the holes. Pull the upper front panel forward until the top panel tabs 2 release from the slots on the chassis (see Figure 3-3). Figure 3-3 DVD-RAM D EPLACING THE...
  • Page 11 IV. Locating and Removing the DVD-RAM Drive 1. Locate the DVD-RAM drive inside the chassis (see Figure 4-1). The drive can be identified by the icons located on the interior drive cage. Look at the replacement part carefully to help identify and locate the component to be replaced.
  • Page 12 3. To release the drive, press in the side rails of the drive 1 and at the same time pull the drive out of the chassis 2 (see Figure 4-3). Figure 4-3 4. Remove the drive rails from each side of the drive and set them aside to be used on the replacement drive (see Figure 4-4).
  • Page 13 V. Replacing the DVD-RAM Drive To replace the DVD-RAM drive, complete the following procedure: Note: Save all the packing materials received with your replacement drive. You will need them to return the defective part. 1. Attach the drive rails you removed from the defective drive to the replacement drive (see Figure 5-1).
  • Page 14 3. Reconnect the power cable 1 1 1 1 , data cable 2 2 2 2 , and audio cable 3 3 3 3 (if there is one) to the new drive (see Figure 5-3). Did you know ... Your DVD-RAM drive jumper will be factory set for cable select (CS) before being shipped.
  • Page 15 VI. Replacing the Upper Front Panel and CD Storage Door (Lower Front Panel) 1. Place the upper front panel in the slots 1 at the top of chassis and gently snap the panel 2 into place (see Figure 6-1). Figure 6-1 DVD-RAM D EPLACING THE RIVE...
  • Page 16 2. Close the CD Storage door (lower front panel) (see Figure 6-2). Figure 6-2 DVD-RAM D EPLACING THE RIVE...

  • Page 17: Replacing The Side Access Panel

    VII. Replacing the Side Access Panel Align the tabs on the top and bottom of the side access panel with the slots (located on the top and bottom edge) on the chassis and slide the side access panel into place (see figure 7-1).
  • Page 18 3. Turn on the computer using the power button and verify that the replacement part is properly installed (see Figure 8-1). Figure 8-1 4. If the problem persists, repeat the Removing and Replacing procedures. 5. If you are still experiencing problems, contact Compaq Support: 1-800-984-9350 DVD-RAM D EPLACING THE RIVE...
  • Page 19 VIII. Returning the Defective Part Please refer to the Compaq Part Return Instructions that came with your replacement part for instructions for returning the defective part. DVD-RAM D EPLACING THE RIVE...
  • Page 20 224545-001 www.compaq.com...

This manual is also suitable for:

7000 series

Table of Contents