(Work in Progress)
A high level logic analyzer for Saleae Logic 2.
This extension provides support for XpressNet 3.0 a protocol by Lenz which is a protocol used in model railroads for communication. To use this analyzer you first need an Async-Serial low lever decoder.
All packets are based on this documentation: XpressNet-V3.0 and XpressNet-V3.6
This analyzer is not complete, the table shows the current progress
The function status functions are corrected. They now show if a function is a momentary or toggle function The new status requests and responses report the status as follows:
| Char | Function | Description |
|---|---|---|
| M | Momentary function | When on a device the function button is pressed the function is ON, when the button is released the function is OFF again |
| T | Toggle function | When on a device the function button is pressed this function is ON, when the button is pressed again the function is OFF |
The address representation has changed. If the high byte of the address is 0x00, than the address is between 0 and 99. Only the low byte is used for the address. If the high byte not is 0x00, than the address is between 100 and 9999. The address is shown as a readable address by filtering out the MSB 15 and 14.
* = Multiple packages of the same type
| Name | Type | Implemented |
|---|---|---|
| Normal inquiry | Inquiry | x |
| Request Acknowledgment | Request | x |
| Normal operation resumed | Broadcast | x |
| Track power off | Broadcast | x |
| Emergency stop | Broadcast | x |
| Service Mode entry | Broadcast | x |
| Feedback Broadcast | Broadcast | |
| Programming info * | Response | |
| Service Mode Response * | Response | |
| Software Version | Response | X |
| Command station status indication | Response | X |
| Transfer Errors | Response | X |
| Command station busy response | Response | X |
| Instruction not supported | Response | X |
| Accessory Decoder information | Response | X |
| Locomotive information * | Response | X |
| Locomotive is being operated | Response | X |
| Function status | Response | X |
| Locomotive information (address retrieval) | Response | X |
| Double Header * | Multiple | |
| MU+DH error | Response |
| Name | Type | Implemented |
|---|---|---|
| Acknowledgment Response | Response | X |
| Resume operations | Request | X |
| Stop operations | Request | X |
| Stop all locomotives | Request | |
| Emergency stop a locomotive | Request | X |
| Register Mode read | Request | |
| Direct Mode CV read | Request | |
| Paged Mode read | Request | |
| Service Mode results | Request | X |
| Register Mode Write | Request | |
| Direct Mode CV Write | Request | |
| Paged Mode write | Request | |
| Command station software version | Request | X |
| Command station status | Request | X |
| Set command station power-up mode | ? | |
| Accessory Decoder information | Request | X |
| Accessory Decoder operation | Request | X |
| Locomotive information | Request | X |
| Function status | Request | X |
| Locomotive speed and direction | Instructions | X |
| Function operation | Instructions | X |
| Set function state | Instructions | X |
| Double header * | Multiple | |
| Operations Mode programming byte mode write | Request | |
| Operations Mode programming bit mode write | Request | |
| Add a locomotive to a multi-unit | Request | |
| Remove a locomotive from a multi-unit | Request | |
| Address inquiry member of a multi-unit | Request | |
| Address inquiry multi-unit | Request | |
| Address inquiry locomotive at command station | Request | |
| Delete locomotive from command station stack | Request |
- Track power off: Short circuit
- Allow setting the accessory decoder address format (turnout, switching decoder, feedback module)
- Handle other accessory decoders than switching decoders