Add support for resetting RP2040 via the USB connection when using pi… #197
Conversation
…co_stdio_usb - setting baud rate to magic value (default=1200) will cause a reset to BOOTSEL mode - a VENDOR interface along side the CDC interface can be used to reset via refular flash boot, or into BOOTSEL mode with control for the reset_usb_boot parameters for the latter either method can be configured/enabled/disabled via #define
kilograham
force-pushed
the
stdio-usb-reset-to-bootsel
branch
from
329ec28
to
ed45e8a
Compare
|
fixes #112 |
| #define PICO_STDIO_USB_RESET_MAGIC_BAUD_RATE 1200 | ||
| #endif | ||
|
|
||
| // PICO_CONFIG: PICO_STDIO_USB_ENABLE_RESET_VIA_BAUD_RATE, Enable/disable resetting into BOOTSEL mode via an additional VENDOR USB interface - enables picotool based reset, type=bool, default=1, group=pico_stdio_usb |
There was a problem hiding this comment.
PICO_STDIO_USB_ENABLE_RESET_VIA_BAUD_RATE here should be PICO_STDIO_USB_ENABLE_RESET_VIA_VENDOR_INTERFACE
|
Looks good. I didn't realise you could implement your own vendor driver like that! |
|
|
||
| // PICO_CONFIG: PICO_STDIO_USB_RESET_RESET_TO_FLASH_DELAY_MS, delays in ms before rebooting via regular flash boot, default=100, group=pico_stdio_usb | ||
| #ifndef PICO_STDIO_USB_RESET_RESET_TO_FLASH_DELAY_MS | ||
| #define PICO_STDIO_USB_RESET_RESET_TO_FLASH_DELAY_MS 100 |
There was a problem hiding this comment.
Just out of curiosity, why would somebody ever need/want to change this?
(especially given that there's no similar "reset delay" for RESET_TO_BOOTSEL)
There was a problem hiding this comment.
the probably don't, but no harm in creating a define since I picked an arbitrary value
| if (request->wValue & 0x100) { | ||
| gpio_mask = 1u << (request->wValue >> 9u); | ||
| } | ||
| reset_usb_boot(gpio_mask, request->wValue & 0x7f); |
There was a problem hiding this comment.
Does there need to be some comments about what request->wValue can be set to, or will that be covered by the picotool source-code?
|
Is there a related change to picotool that make use of this vendor interface? Or some other simple test script? |
I didn't either until I found out the default one forced you to use endpoints (also this way pulls in much less code) |
not public yet; i tested it locally within picotool, so i could release this, but the picotool changes will come soon separately |
|
The big question with this is now: How can the actual application (i.e. what I as a user of the SDK write) implement custom class drivers in my application? It looks like the pico SDK is using this feature of tiny-usb for internal purposes? |
…co_stdio_usb
either method can be configured/enabled/disabled via #define