Skip to content

openradarinitiative/openradar_mmwave_utils

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 

History

7 Commits
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

Open Radar mmwave utils

Repository for TI MMWave utils and simple processing.
This repository contains:

  • A dirty linux port of TI's MMWave example
  • A dirty linux port of TI's DCA1000 example
  • Example python sofware for radar processing using CUPY

Setup and get started

Perform the following steps to get started:

Install dependencies:

Install the dependencies as described in installation instructions.

Connect the radar

  • Connect the micro-USB port on the DCA1000 to your system
  • Connect the AWR2243 to a 5V barrel jack
  • Set power connector on the DCA1000 to RADAR_5V_IN
  • Put the device in SOP0
    • Jumper on SOP0, all others disconnected
  • Connect the RJ45 to your system
  • Set a fixed IP to the local interface: 192.168.33.30

Fix the user priviliges:

sudo touch /etc/udev/rules.d/99-libftdi.rules 
sudo gedit /etc/udev/rules.d/99-libftdi.rules 

Add the following line:

SUBSYSTEM=="usb", ATTR{idVendor}=="0451", ATTR{idProduct}=="fd03", GROUP="usb", MODE="0664"

Then create the group and add your user:

sudo useradd -G usb $USER$
sudo usermod -a -G usb $USER$

Build and run the code

There are two utils that need to be built:

  • MMWavelink - sets up the radar
  • DCA1000 - Starts the stream

Build and run the MMWavelink code

To build and setup the code, follow the common CMAKE-way of doing it:

cd setup_radar  
mkdir build
cd build
cmake ..
make -j4

And then, run the following to setup the radar:

sudo ./setup_radar

This takes a bit of time, but the output should end with:

=========== mmWaveLink Example Application execution Successful ===========

A full printout of the output is here

Build and run the DCA1000 utils

To build and setup the code, follow the common CMAKE-way of doing it:

cd setup_dca_1000  
mkdir build
cd build
cmake ..
make -j4

And then, run the following to setup the DCA1000 to stream:

./setup_dca_1000

The output should be:

RDFCard Configure RDFCard_FPGA sendt!
Sendt message

FPGA Configuration command : Success
Handshake sendt!
Sendt message
Start Record Data sendt
Sendt message

And the DCA1000 should start blinking - which is a great sign!

About

No description, website, or topics provided.

Resources

License

Stars

Watchers

Forks

Releases

No releases published

Packages

No packages published