WiFi/USB capable version of the famous Black Magic Probe debugger. Based on firmware for Flipper Zero WiFi dev board.

Clone the repository with:

git clone --recursive https://github.com/m1nl/blackmagic-esp32.git

You must recursively clone the submodules, which --recursive will do for you. When you pull new changes, be sure to run git submodule update --init --recursive.

Set up ESP-IDF following Espressif's instructions. Make sure idf.py is in your PATH and you can successfully run the program.

In your clone of this repository, run:

idf.py build

Note: the sdkconfig file already configures the project to target the ESP32.

Connect the dev board to your computer with a USB cable. Find the name of the serial port device on your computer that corresponds to the dev board. See the Espressif's guide on how to find the port name.

Run:

idf.py -p <port> flash

Connect to the dev board with:

idf.py -p <port> monitor

You should not see errors in the logs if the firmware is installed and running correctly.

SWCLK is GPIO25

SWDIO is GPIO26

Can be changed in file components/blackmagic/esp32-platform/platform.h