Vallox SE (RS-485 supported) ventilation control software for ESP-01 & Home Assistant integration
See guide at https://www.creatingsmarthome.com/?p=73
Thanks for original vallox libary implementation by dirtyha: https://github.com/dirtyha/my-esp8266/tree/master/Vallox
- Vallox 096 SE
- Vallox 110 SE
- Vallox 121 SE (version without front heating module)
- Vallox 121 SE (version with front heating)
- Vallox 150 SE
- Vallox 270 SE
- Vallox Digit SE
- Vallox Digit SE 2
- Vallox ValloPlus 350 SE
- Vallox ValloPlus SE 500
Contained entities:
- climate: Climate sensor has basic functionalty like mode: heat/ fan, fan speed: 1-8, heat target
- status: Binary status sensor (on/off) that has multiple read-only attributes
- switch: Switch is used to perform boost or fireplace function (depending which one you have selected from vallox configuration)
- sensor: switch type to see if switch is configured as fireplace or boost
- sensors: outside, inside, exhaust and incoming temperatures
- sensors: rh1 and rh2 if supported by your Vallox Ventilation machine
- sensor: co2 if supported by your Vallox Ventilation machine
- binary sensors: motor in/motor out statuses
- binary sensor: summer mode
- sensor: service counter (how many months until you have to replace your filters)
See guide at https://www.creatingsmarthome.com/?p=105
Configuration is no longer possible by using configurations.yaml. Please use UI configuration from integrations!
If you have old configuration in configurations.yaml, please remove it and make a new configuration through UI.
