qaz-ish alice style handwired board

sound test: https://youtu.be/haUENY8KfjM

• qaz-ish alice layout
• gasket mount
• 5mm thick plate
• clear window on the back to display wiring
• via support (if you choose to wire the matrix the same as I did)

• 35x mx style switches
• 35x diodes
• elite-c controller (the cutout on the bottom is specifically designed for an elite-c, so a promicro will not work)
• wires of your choice
• gaskets (This is designed to work with KBDFans's D65 gaskets, but any gaskets should work as long as they are not over 4mm wide)
• 8x m2x6 screws
• (optional) 2x 2u plate mount stabilizers
• (optional) bumpons/feet (I used 3m sj1502s, but any feet 8mm in diameter should work)
• (optional) clear plastic/acryllic sheet for the window on the back

• should go without saying, but the board has to be wired exactly as the "matrix.png" shows for the firmware to work
• use qmk toolbox to flash the hex file onto the board
• to get the board properly showing up in via, you will need to go into via > file > import keymap and then select the "C-13X.json" file, then it should show up

I do not sell any products. I have seen several vendors selling my designs, but these are not endorsed by me. If you decide to support these sellers I am not responsible for any issues you may encounter with them.