The DIY Solder Reflow
Designed With KICAD
- 🥑 Built In 5V and 3.3v Voltage Source
- 0️⃣ Built in SSR Zero Crossing
- ⛓️ Built In USB Serial Interface
- 🎣 Use TL074 For PT100 Signal Conditioning
- 🌮 5 Programmable User Input
- 🍒 Use ESP32-Wroom
- 🥓 10 Pin JTAG Connector
- 🧢 0.91' OLED or 1.3' TFT
Several Notes
this is just my own diy solder reflow made from seferal reference accross internet. at initial of this project, i want:
- use ptc heater instead of iron
- design some case for this project
- use esp32 or wemos
- use native toolchain instead arduino
- make good documentation about this project
Work In Progress, Made with