- These scripts aid in setting up your current ADS-B receiver to feed adsb.fi.
- This will not disrupt any existing feed clients already present.
- When setting up new feeders, a decoder such as readsb must be installed separately.
https://www.freemaptools.com/elevation-finder.htm
curl -L -o /tmp/feed.sh https://adsb.fi/feed.sh
sudo bash /tmp/feed.sh
netstat -t -n | grep -E '30004|31090'
Expected Output:
tcp 0 182 localhost:43530 65.109.2.208:31090 ESTABLISHED
tcp 0 410 localhost:47332 65.109.2.208:30004 ESTABLISHED
4: Optional: Install local interface for your data
The interface will be available at http:https://192.168.X.XX/adsbfi
Replace the IP address with the address of your Raspberry Pi.
Install / Update:
sudo bash /usr/local/share/adsbfi/git/install-or-update-interface.sh
Remove:
sudo bash /usr/local/share/tar1090/uninstall.sh adsbfi
curl -L -o /tmp/update.sh https://raw.githubusercontent.com/adsbfi/adsb-fi-scripts/master/update.sh
sudo bash /tmp/update.sh
If you encounter issues, please do a reboot and then supply these logs on Discord (last 20 lines for each is sufficient):
sudo journalctl -u adsbfi-feed --no-pager
sudo journalctl -u adsbfi-mlat --no-pager
cat /etc/default/adsbfi
If your feeder is on a separate device from the one this script is installed.
Edit config sudo nano /etc/default/adsbfi and change the IP on the following lines to point to your feeder device's IP:
INPUT="127.0.0.1:30005"
...
UAT_INPUT="127.0.0.1:30978"
Then restart the feed client:
sudo systemctl restart adsbfi-feed
sudo systemctl restart adsbfi-mlat
This is the same as the initial installation. If the client is up to date it should not take as long as the original installation, otherwise this will also update the client which will take a moment.
curl -L -o /tmp/feed.sh https://raw.githubusercontent.com/adsbfi/adsb-fi-scripts/master/install.sh
sudo bash /tmp/feed.sh
Alternatively edit the config directly and restart the feed client
sudo nano /etc/default/adsbfi
sudo systemctl restart adsbfi-feed
sudo systemctl restart adsbfi-mlat
This is enabled by default. You probably don't need to change that.
- Disable:
sudo sed --follow-symlinks -i -e 's/RESULTS=.*/RESULTS=""/' /etc/default/adsbfi
sudo systemctl restart adsbfi-mlat
- Enable:
sudo sed --follow-symlinks -i -e 's/RESULTS=.*/RESULTS="--results beast,connect,127.0.0.1:30104"/' /etc/default/adsbfi
sudo systemctl restart adsbfi-mlat
sudo systemctl restart adsbfi-feed
sudo systemctl restart adsbfi-mlat
sudo systemctl status adsbfi-feed
sudo systemctl status adsbfi-mlat
sudo bash /usr/local/share/adsbfi/uninstall.sh
If the above doesn't work, you can just disable the services and the scripts won't run anymore:
sudo systemctl disable --now adsbfi-feed
sudo systemctl disable --now adsbfi-mlat
