• Right-click to place an item and left click to destroy an item. Press W to move forward, A to move left, D to move right, S to move backward and Space Bar to jump. Use the number keys 0-9 to toggle through inventory.
• Track joins are only detected on block updates in some cases. Even though this is fixed, you might need to trigger one by breaking a block adjacent to the track to update. This is shown in the GIFs below.

1. First, you will have to setup Terasology.
2. Then you will have to set up the Rails module.
3. Then you are ready to go to next step!

Verify the game does not crash or hang at any of the following steps.

1. Create a new world with only rails and its dependencies active from the modules.
2. Verify the world is created and loads.
3. Verify your inventory contains 1 Minecart, 1 Spanner, and 99 Rails. (in some cases few of these items are not available, as it gives a default block. You will need run the following code: gradlew run or re-clone the repo).

---

To get more rails, first press F1 key then type-in give Rails:Rails to get more track as needed.

1. Place three rails in an elbow bend.
2. Check the center rail has changed to a bend.
3. If not, change the center rail.

1. Place four rails in a T-shape.
2. Check that the center rail has turned into a junction.
3. If not, destroy the middle rail and place it back again.

1. Place three rails in a straight line.
2. Check they all snap to face the same way.

1. Place three tracks in a line, with the end one elevated on one block.
2. Verify the middle track is sloped upwards towards the elevated block.

1. Create a ‘staircase’ of 2 or more blocks with an elevation of one block between blocks on the staircase.
2. Place three or more rails in a line.
3. Verify that the tracks connect and are sloped upwards towards the elevated block before it.

1. Create a Tee joint as detailed Above.
2. Press e on it with the spanner.
3. Verify the direction has switched.
4. Press e on it with the spanner again.
5. Verify the direction has switched back.

---

1. Place tracks in a small loop (eg 4x8 blocks).
2. Place a minecart on the loop.
3. Verify it appears and is on the tracks.
4. Enter it by pressing e over it.
5. Verify you enter the cart.
6. Exit the cart using e over it again.
7. Verify you have exited the cart.
8. Move the cart by pushing it.
9. Verify the cart moves around the loop.
10. Stop pushing the cart.
11. Verify the cart stops.
12. Destroy the cart by left-clicking it.
13. Verify the cart is destroyed.

1. Place tracks in a straight line.
2. Leave one block ahead(gap) of the straight line and place one track in front of the gap.
3. Place a minecart on the straight line track.
4. Push the cart till the end.
5. Verify that the cart has moved out of the track and onto the ground.