This product is currently under development!
This product is a module enabling the SUSTAINA-OP/ICM-42688-P-Module (IMU module) to be connected to a USB or RS-485 I/F through a microcontroller.
The firmware for this product to be written to the microcontroller is a modification of the following library.
| Top Surface of PCB | Bottom Surface of PCB | Assembled Electronic Components |
|---|---|---|
 |
 |
- 87mm x 25mm PCB layout
This product is designed with the following software.
- \images
- PCB preview images and capture of design screen
- \libraries
- Libraries used in Autodesk Eagle design
- \pcb_order
- Gerber data and documentation for ordering PCB
- \firmware
- Sample firmware to be written to the microcontroller board
- schematic.pdf
- Circuit diagram of this product
- *.brd
- Board wiring design file by Autodesk Eagle
- *.sch
- Circuit diagram design file by Autodesk Eagle
- .gitignore
- A file that tells Git not to track a particular file
- LICENSE
- License to use this product
The following design errors have been identified in Rev. 1 of this product.
- TXDEN of UART/RS-485 conversion IC is not wired to the microcontroller board When used with USB I/F, there is no problem, but when used with RS-485 I/F, solder a jumper wire between TXDEN and the microcontroller as shown in the figure below.
If you have any questions, please contact the designer of this product, Masato Kubodera, by e-mail.
E-mail: [email protected]
This product is open source. Please review the LICENSE for license information.
This product by Masato Kubotera is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.