This plugin allows the user to easilly configure and control a PWM light for Raspberry PI GPIOs. The Light controls will show up on the controls tab as shown in the screenshots below. Additionally, the user can configure light values per light control entity for various Octoprint events such as printer connect / disconnect, print start / end, ...

Install via the bundled Plugin Manager or manually using this URL:

https://github.com/RoboMagus/OctoPrint-LightControls/archive/main.zip

The end user is responsible for setting up the gpio configuration used in this plugin and the corresponding wiring correctly. Failure to do so could damage your Raspberry Pi! I cannot be held accountable for any damages.

Many PWM controlled Lights can be added through the plugins settings menu. In the top section you can add the light and give it a name, select the pin to use, etc. Enabling and Disabling the lights automatically on e.g. print start / stop can be configured in the section below. Here you can enter the light value as a percentage of full brightness. Empty fields imply the light will remain untouched when the event occurs.

In versions >= 0.4.3 support for Hardware PWM is added to mittigate the flickering effects that users may experience caused by the software PWM used by default (See issue #6).

The use of Hardware PWM needs additional configuration to the Raspberry pi config. The applicable PWM overlays need to be added to the /boot/config.txt file. Details and options are best described here.

Note that Hardware PWM on the Pi is limited to pins 12, 13, 18 and 19! For each of these pins, the following overlays should be added to /boot/config.txt:

Once these changes are applied and the Pi is rebooted(!), this plugin will automatically attempt to use Hardware PWM on any of these pins when they are configured to act as PWM lights.

As per version 0.3.0 this plugin supports a few helper functions that can be used by other plugin developers to interact with LightControls. These helper functions are:

• get_light_names(): returns an array of strings containing all configured light names.
• get_light_value(light_name): returns an integer light value as a percentage of brightness (0 to 100) for the provided light_name if the entity exists. Returns None otherwise.
• set_light_value(light_name, light_value): sets the light_value (from 0 to 100) for provided light_name and returns the set value if succesfull. Returns None otherwise.

An example of how to use these helpers:

helpers = self._plugin_manager.get_helpers("LightControls")
if helpers:
    if "get_light_names" in helpers:
        light_names = helpers["get_light_names"]()
        self._logger.info(f"Light names: {light_names}")
        if "get_light_value" in helpers:
            self._logger.info("Light values before reset:")
            for name in light_names:
                self._logger.info("Light '{}' value: {}".format(name, helpers["get_light_value"](name)))
        if "set_light_value" in helpers:
            set_light_value = helpers["set_light_value"]
            self._logger.info("Light values after reset:")
            for name in light_names:
                value = set_light_value(name, 0)
                self._logger.info(f"Light '{name}' value: {value}")

• Add support for hardware PWM (Should improve #2)
• ...