This bash script offers quick shortcuts to simulate slower network connections. It is useful when you need to simulate a wireless network on a Linux network server, especially when you are using a virtual machine guest on your local machine or in the cloud.

slow 3G                   # Slow network on default eth0 down to 3G wireless speeds
slow reset                # Reset connection for default eth0 to normal
slow vsat                 # Simulate satellite internet  with a high latency
slow dsl -b 1mbps         # Simulate DSL with a slower speed than the default
slow modem-56k -d eth1    # Simulate a 56k modem on the eth1 device. eth0 is unchanged.
slow -b 100000 -l 100ms   # Simulate network with a 100k bandwidth and 100ms latency
slow T1 -p 0.1%           # Simulate T1 line with 1 in 1000 packet loss
slow T3 -c 0.1%           # Simulate T3 line with 1 in 1000 packet corruption

If you assign more than one network interface to a virtual guest, you could run slow on one of the interfaces, so that it you can switch between fast and slow connections by switching the IP address endpoint.

Slow requires Linux and the 'tc' suite of traffic control tools.

See the Cisco Global Cloud Index Supplement for statistics on bandwidth and latency for countries all over the world.

The available built-in targets simulate many common network scenarios. They start out without assuming clear transmissions without extra delays, corruptions, or duplications.

By adding extra command line parameters you can tweak the behavior of the network interface further, adding precise bandwidth and latency tweaks, or add packet loss or corruption.

This project is set up with Vagrant to make it convenient to test, even if you are not running Linux as your host operating system.

Install Vagrant and Virtualbox and issue the command vagrant up and then you can experiment with the different commands, for example:

vagrant up
vagrant ssh 
# wait for vagrant prompt 
sudo /vagrant/slow 56k

Richard Bullington-McGuire [email protected] wrote the script inspired by a UI suggestion from Mike Schwartz [email protected]. Tyler Knappe and Adrian Silva helped clean up the script.

Stack Overflow and Superuser questions that helped:

• http:https://stackoverflow.com/questions/402377/using-getopts-in-bash-shell-script-to-get-long-and-short-command-line-options/7680682#7680682
• http:https://superuser.com/questions/147156/simulating-a-low-bandwidth-high-latency-network-connection-on-linux

An Aptivate blog post lent some inspiration, as did this script for throttling bandwidth.

It would be nice to expand the options that this took more options, such as adjusting for random fluctuations in speed, packet reordering, and smarter packet dropping. Reading up on the Linux Advanced Routing and Traffic Control HOWTO should provide food for thought.