Gantry Squaring Suggestion

[IRTrail]

During the process of rebuilding my V2, I decided to re-square my gantry. I found the Z locks quite useful:
https://github.com/VoronDesign/VoronUsers/tree/master/printer_mods/tallman5/z-locks/

They hold the gantry at a set and even height relative to the frame. They also prevent the gantry from falling if the Z belt is loosened a bit too much.

I also did a squaring with the GE5C mod installed, and this, with the Z locks installed pretty well locks the gantry in place. Thus, just loosen the attach points, and retighten and it is perfect with in an N95/95 tolerance. I wrote about it here:
https://github.com/IRTrail/Voron-Stuff/blob/main/Voron_2_Gantry_Squaring.md

At any rate, the Z locks help, a lot. Just a suggestion.

[AndrewEllis93]

Added note in 60efeb5