Add infill_anchor_max note

articles/troubleshooting/small_infill_areas_overextruded.md

@@ -58,8 +58,12 @@ This is default behavior in Cura, and is not available in Prusa Slicer.
  - [![](./images/small_infill_overextruded/overshoot.png)](./images/small_infill_overextruded/overshoot.png){:target="_blank"}
  - Reset infill/perimeter encroachment
  - [![](./images/small_infill_overextruded/encroachment_setting.png)](./images/small_infill_overextruded/encroachment_setting.png){:target="_blank"}
- - **:warning: Don't set it too low, however, as it also affects sparse infill**. A low value can cause sparse infill to become detached from the perimeters:
+ - **:warning:Setting it low can cause sparse infill to disconnect**.
  - [![](./images/small_infill_overextruded/infill_disconnect.png)](./images/small_infill_overextruded/infill_disconnect.png){:target="_blank"}
+ - One fix for this is to enable `infill_anchor_max`:
+ - [![](./images/small_infill_overextruded/infill_anchor_max.png)](./images/small_infill_overextruded/infill_anchor_max.png){:target="_blank"}
+ - Result:\
+ [![](./images/small_infill_overextruded/infill_disconnect_fix.png)](./images/small_infill_overextruded/infill_disconnect_fix.png){:target="_blank"}
 
 #### What it Does