This is the AdMeta blockchain implementation.

First, complete the basic Rust setup instructions.

Use Rust's native cargo command to build and launch the AdMeta node:

cargo run --release -- --dev

The cargo run command will perform an initial build. Use the following command to build the node without launching it:

cargo build --release

Once the project has been built, the following command can be used to explore all parameters and subcommands:

./target/release/admeta -h

The provided cargo run command will launch a temporary node and its state will be discarded after you terminate the process. After the project has been built, there are other ways to launch the node.

This command will start the single-node development chain with non-persistent state:

./target/release/admeta --dev

Purge the development chain's state:

./target/release/admeta purge-chain --dev

Start the development chain with detailed logging:

RUST_BACKTRACE=1 ./target/release/admeta -ldebug --dev

Development chain means that the state of our chain will be in a tmp folder while the nodes are running. Also, alice account will be authority and sudo account as declared in the genesis state. At the same time the following accounts will be pre-funded:

• Alice
• Bob
• Alice//stash
• Bob//stash

In case of being interested in maintaining the chain' state between runs a base path must be added so the db can be stored in the provided folder instead of a temporal one. We could use this folder to store different chain databases, as a different folder will be created per different chain that is ran. The following commands shows how to use a newly created folder as our db base path.

// Create a folder to use as the db base path
$ mkdir my-chain-state

// Use of that folder to store the chain state
$ ./target/release/admeta --dev --base-path ./my-chain-state/

// Check the folder structure created inside the base path after running the chain
$ ls ./my-chain-state
chains
$ ls ./my-chain-state/chains/
dev
$ ls ./my-chain-state/chains/dev
db keystore network

Once the AdMeta node is running locally, you can connect it with Polkadot-JS Apps front-end to interact with your chain. Click here connecting the Apps to your local AdMeta node.

First, install Docker and Docker Compose.

Then run the following command to start a single node development chain.

./scripts/docker_run.sh

This command will firstly compile your code, followed by the whole unit test run, and then start a local development network.

Run cargo test command to build and launch all unit tests. The unit tests will stop if all tests pass or any of them fails.

cargo test

Please see the AdMeta WebApp guide about how to test using AdMeta WebApp to interact with AdMeta Testnet.

GPLv3