Scan device around, then notify a server and/or flag a pin.

At the first start, join the free "HelloWorld" WiFi. The config portal is on https://{ip}/portal or https://wicheck.local/portal.

Setup your config.

Then click on "reboot" and let it works.

• basicAuth: credentials for accessing to the portal page
• SSID: name and password of the WiFi; when WiCheck can not join a known WiFi it turn itself as an Access Point
• channel: selected channel when WiCheck is an Access Point
• hidden: visibility of the Access Point mode
• timeout: how many time in seconds a device can be hidden before WiCheck forgets it
• auto reboot: reboot WiCheck until a known WiFi is joinned

NB: when a parameter is changed a save button appears. Click on it for saving... It the same behaviours for every config part.

List your friendly WiFi:

• WiFi credentials where WiCheck will connect

When you add a WiFi, first click on + then on the save button.

List your friendly devices (even if there are not connected or not on a friendly WiFi):

• id: keep it unique, there were a reference into the rules
• name: any name for humans
• MAC: stalked MAC address, must use the pattern aa:aa:aa:aa:aa:aa:aa

When you add a Device, first click on + then on the save button.

List your rules, an event is fired as soon as a rule is detected (depending the direction):

• name: any name for humans
• pin: ESP8266 GPIO number, or set 255 if no pin action is required If you use a Wemos Mini D1, D0 is GPIO16, D1 is GPIO5, etc.
• {key}: parameter replaced into Transport URI and Transport Payload (cf next section)
• {value}: parameter replaced into Transport URI and Transport Payload (cf next section) (see Grammar)
• direction: do the action if the new value is:
  • 'checked': more than the previous one onSwitchOn
  • 'indeterminate': not equals the previous one onToggle
  • 'unckecked': less than the previous one onSwitchOff

When you add a Rule, first click on + then on the save button.

Like a webhook, you can define a HTTP request that will be sent for each event defined by Rules.

• method: HTTP method
• uri: uri of the request, {key} and {value} are replaced by the value of the verified Rule
• payload: sent content, {key} and {value} are replaced by the value of the verified Rule

Could be combined to a webrelay controller

The rules used the RPN (Reverse Polish Notation).

Tokens are:

• {integer}
• '@'{integer}: give the visibility of the Device linked by the same ID: 0="not detected", 1="detected"

Operators:

Switch on a light if any Device is detected:

• value: @0 @1 + @2 + @3 +
• direction: checked

Switch off a light if nobody is detected (or close the shutters):

• value: @0 @1 * @2 * @3 *
• direction: unchecked