This mod allows you to use your Densha de GO! Plug & Play as a USB controller for other games.
- USB flash drive
- Powered micro USB OTG adapter
- Micro USB data cable
- Prepare the USB flash drive by formatting it with a single FAT32 partition.
- Download the latest release from the Releases section.
- Extract the content to the root of the USB drive.
- Plug the USB drive to the OTG adapter, plug the adapter to the Plug & Play and plug the data cable to the adapter and a power source.
- Turn on the Plug & Play. The door lamp will turn on to show the installation has begun. Once it has finished, the lamp will turn off. Turn off the unit and remove everything.
Connect the Plug & Play to a PC or console using the data cable. Press one of the following button combinations to select the controller you want to emulate:
| Controller | Button combination | Notes |
|---|---|---|
| One handle controller (Nintendo Switch) | UP | SELECT+START=HOME, SELECT+LEFT=L, SELECT+RIGHT=R |
| Two handle controller (PC) | RIGHT | D-Pad is mapped to SELECT+ABCD |
| Two handle controller (PS1) | DOWN + Power handle at 0 | Hold D to disable handles and enable D-Pad |
| Two handle controller "Type 2" (PS2) | D | |
| Shinkansen controller (PS2) | B | Power notches are mapped to P2-P4-P7-P10-P13 |
| Multi Train Controller (PS2) - P4/B7 | C + Power handle at 0 | SELECT+A=A2, SELECT+D=ATS, SELECT+D-Pad=Reverser |
| Multi Train Controller (PS2) - P4/B2-B7 | C + Power handle at 1 | SELECT+A=A2, SELECT+D=ATS, SELECT+D-Pad=Reverser |
| Multi Train Controller (PS2) - P5/B5 | C + Power handle at 2 | SELECT+A=A2, SELECT+D=ATS, SELECT+D-Pad=Reverser |
| Multi Train Controller (PS2) - P5/B7 | C + Power handle at 3 | SELECT+A=A2, SELECT+D=ATS, SELECT+D-Pad=Reverser |
Hold the buttons until the controller vibrates to confirm selection. If no button is pressed, you can play with the Plug & Play as usual.
If you need more information regarding each controller and supported software, please check the Densha de GO! controller documentation.
When no controller is selected, RNDIS access is enabled in the device. You can access SSH on the Plug & Play at 169.254.215.100. SFTP is not supported out of the box, but SCP is available. Keep in mind the root filesystem is mounted read-only by default.
- During the first installation, if no previous mods are detected, the device's original kernel is backed up to a folder named BACKUP in the root of the USB drive. Copy its contents to a safe location.
- If detected, the original mod by GMMan will be uninstalled to avoid conflicts.
To compile the program yourself, you will need Rust and toolchain for Armv7-A. The easiest way is to install cross and run:
cross build --target arm-unknown-linux-musleabi --release
The Linux kernel source can be found here.