Chapter 13 Properties of Solutions. Solutions Solutions are homogeneous mixtures of two or more pure substances. In a solution, the solute is dispersed.

Presentation on theme: "Chapter 13 Properties of Solutions. Solutions Solutions are homogeneous mixtures of two or more pure substances. In a solution, the solute is dispersed."— Presentation transcript:

1 Chapter 13 Properties of Solutions

2 Solutions Solutions are homogeneous mixtures of two or more pure substances. In a solution, the solute is dispersed uniformly throughout the solvent.

3 Solutions The intermolecular forces between solute and solvent particles must be strong enough to compete with those between solute particles and those between solvent particles.

4 How Does a Solution Form? As a solution forms, the solvent pulls solute particles apart and surrounds, or solvates, them.

5 How Does a Solution Form If an ionic salt is soluble in water, it is because the ion- dipole interactions are strong enough to overcome the lattice energy of the salt crystal.

6 Energy Changes in Solution Simply put, three processes affect the energetics of solution: –separation of solute particles, –separation of solvent particles, –new interactions between solute and solvent.

7 Energy Changes in Solution The enthalpy change of the overall process depends on  H for each of these steps.

8 Why Do Endothermic Processes Occur? Things do not tend to occur spontaneously (i.e., without outside intervention) unless the energy of the system is lowered.

9 Why Do Endothermic Processes Occur? Yet we know the in some processes, like the dissolution of NH 4 NO 3 in water, heat is absorbed, not released.

10 Enthalpy Is Only Part of the Picture The reason is that increasing the disorder or randomness (known as entropy) of a system tends to lower the energy of the system.

11 Enthalpy Is Only Part of the Picture So even though enthalpy may increase, the overall energy of the system can still decrease if the system becomes more disordered.

12 Be careful! Just because a substance disappears when it comes in contact with a solvent, it doesn’t mean the substance dissolved.

13 Be Careful! Dissolution is a physical change — you can get back the original solute by evaporating the solvent. If you can’t, the substance didn’t dissolve, it reacted.

14 Types of Solutions Saturated –In a saturated solution, the solvent holds as much solute as is possible at that temperature. –Dissolved solute is in dynamic equilibrium with solid solute particles.

15 Types of Solutions Unsaturated –If a solution is unsaturated, less solute than can dissolve in the solvent at that temperature is dissolved in the solvent.

16 Types of Solutions Supersaturated –In supersaturated solutions, the solvent holds more solute than is normally possible at that temperature. –These solutions are unstable; crystallization can usually be stimulated by adding a “seed crystal” or scratching the side of the flask.

17 Factors Affecting Solubility Chemists use the axiom “like dissolves like." –Polar substances tend to dissolve in polar solvents. –Nonpolar substances tend to dissolve in nonpolar solvents.

18 Factors Affecting Solubility The more similar the intermolecular attractions, the more likely one substance is to be soluble in another.

19 Factors Affecting Solubility Glucose (which has hydrogen bonding) is very soluble in water, while cyclohexane (which only has dispersion forces) is not.

20 Factors Affecting Solubility Vitamin A is soluble in nonpolar compounds (like fats). Vitamin C is soluble in water.

21 Gases in Solution In general, the solubility of gases in water increases with increasing mass. Larger molecules have stronger dispersion forces.

22 Gases in Solution The solubility of liquids and solids does not change appreciably with pressure. The solubility of a gas in a liquid is directly proportional to its pressure.

23 Henry’s Law S g = kP g where S g is the solubility of the gas, k is the Henry’s Law constant for that gas in that solvent, and P g is the partial pressure of the gas above the liquid.

24 Temperature Generally, the solubility of solid solutes in liquid solvents increases with increasing temperature.

25 Temperature The opposite is true of gases. –Carbonated soft drinks are more “bubbly” if stored in the refrigerator. –Warm lakes have less O 2 dissolved in them than cool lakes.

26 Mass Percentage Mass % of A = mass of A in solution total mass of solution  100

27 moles of A total moles in solution X A = Mole Fraction (X) In some applications, one needs the mole fraction of solvent, not solute — make sure you find the quantity you need!

28 mol of solute L of solution M = Molarity (M) You will recall this concentration measure from Chapter 4. Since volume is temperature- dependent, molarity can change with temperature.

29 mol of solute kg of solvent m = Molality (m) Since both moles and mass do not change with temperature, molality (unlike molarity) is not temperature- dependent.

30 Changing Molarity to Molality If we know the density of the solution, we can calculate the molality from the molarity and vice versa.

31 Colligative Properties Changes in colligative properties depend only on the number of solute particles present, not on the identity of the solute particles. Among colligative properties are –Vapor pressure lowering –Boiling point elevation –Melting point depression –Osmotic pressure

32 Vapor Pressure Because of solute- solvent intermolecular attraction, higher concentrations of nonvolatile solutes make it harder for solvent to escape to the vapor phase.

33 Vapor Pressure Therefore, the vapor pressure of a solution is lower than that of the pure solvent.

34 Raoult’s Law P A = X A P  A where –X A is the mole fraction of compound A, and –P  A is the normal vapor pressure of A at that temperature. NOTE: This is one of those times when you want to make sure you have the vapor pressure of the solvent.

35 Boiling Point Elevation and Freezing Point Depression Nonvolatile solute- solvent interactions also cause solutions to have higher boiling points and lower freezing points than the pure solvent.

36 Boiling Point Elevation The change in boiling point is proportional to the molality of the solution:  T b = K b  m where K b is the molal boiling point elevation constant, a property of the solvent.  T b is added to the normal boiling point of the solvent.

37 Boiling Point Elevation The change in freezing point can be found similarly:  T f = K f  m Here K f is the molal freezing point depression constant of the solvent.  T f is subtracted from the normal boiling point of the solvent.

38 Boiling Point Elevation and Freezing Point Depression Note that in both equations,  T does not depend on what the solute is, but only on how many particles are dissolved.  T b = K b  m  T f = K f  m

39 Colligative Properties of Electrolytes Since these properties depend on the number of particles dissolved, solutions of electrolytes (which dissociate in solution) should show greater changes than those of nonelectrolytes.

40 Colligative Properties of Electrolytes However, a 1M solution of NaCl does not show twice the change in freezing point that a 1M solution of methanol does.

41 van’t Hoff Factor One mole of NaCl in water does not really give rise to two moles of ions.

42 van’t Hoff Factor Some Na + and Cl - reassociate for a short time, so the true concentration of particles is somewhat less than two times the concentration of NaCl.

43 van’t Hoff Factor Reassociation is more likely at higher concentration. Therefore, the number of particles present is concentration- dependent.

44 van’t Hoff Factor We modify the previous equations by multiplying by the van’t Hoff factor, i.  T f = K f  m  i

45 Osmotic Pressure The pressure required to stop osmosis, known as osmotic pressure, , is nVnV  = ( ) RT = MRT where M is the molarity of the solution. If the osmotic pressure is the same on both sides of a membrane (i.e., the concentrations are the same), the solutions are isotonic.

46 Colloids Suspensions of particles larger than individual ions or molecules, but too small to be settled out by gravity are called colloids.

47 Tyndall Effect Colloidal suspensions can scatter rays of light. This phenomenon is known as the Tyndall effect.

48 Colloids in Biological Systems Some molecules have a polar, hydrophilic (water-loving) end and a non-polar, hydrophobic (water- hating) end.