This type of enclosure is built around LilyGO® T-Echo board.
NOTICE: This design is applicable for pre-production sample of the T-Echo. Other revisions may or may not match.
The enclosure is designed to fit for a 40 x 30 x 8 mm 1000 mAh Li-Po battery.
3D print two STL files from this folder: Body and Face. You may pick some printing advisories on my Thingiverse page.
If you are unable to print the parts by yourself - you may consider to find an appropriate local 3D service provider and place an order with assistance of Treatstock or 3DHubs portals.
- connect GNSS antenna to the board ;
- connect SMA pigtail to the board ;
- connect battery to the board with JST 1.25mm 2pin female plug ;
- place the battery first ;
- then place T-Echo board into the enclosure's main body ;
- fasten the board with two 2.5x10 mm screws.
- put lid on top of the assembly.
This variant of the Body part is designed to fit for a 20 mm wrist or neck strap.