Lobaro Maintenance Tool

Changelog

1.4.9 - 17.09.2019

Fix a bug where flashing firmware fails due to UART buffer issues

1.4.4 - 11.09.2019

Fix a bug that failed to flash very big firmware files.
Add delays when communicating with Bootloader to avoid timing issues.
Flash command now support --verbose flag

1.4.3 - 30.07.2019

Fix a bug where writing the config does not work.

1.4.2 - 29.07.2019

Fix a bug where the program hangs up while connecting to a wrong serial port in "auto" mode.
Fix a bug where the tool crashes when flashing the firmware while not connected.

1.4.0 - 10.08.2018

Log Tool events like Connect, Disconnect, Read Config, etc. to UART Log
Switch to firmware mode after connecting with "auto" port

1.3.4 - 09.08.2018

Always switch to Firmware run mode after: Connect, Load Config, Restore Config.

1.3.3

Internet Explorer support

1.3.2 - 09.07.2018

Fix reading configs bigger than 256 Bytes (needed for wMbus Bridge)

1.3.0 - 21.03.2018

Improve connection detection
Allow to connect to specific serial port
Do not reset to boot mode when connecting to selected serial port

1.2.5 - 07.03.2018

Fix issues with loading a configuration file. Default is now "config.yaml"
Remove horizontal scrollbars in tabs
Add "Set Time" button to send "time=" via UART
Add send UART input below Log
Display if Firmware or Booloader is running
Add success message when loading config

1.2.4 - 07.03.2018

Allow to replace assets e.g. the logo by placing /assets/logo.png next to the executable

1.2.3 - 05.03.2018

Log Timestamp in UART log file on disk
Allow to set http server ip and port to allow remote access

1.2.2 - 19.02.2018

Fix CBOR decoding error that was introduced in 1.2.0 (see: ugorji/go#232)

1.2.0 - 16.02.2018

Fix Serial port issues that appear on MAC, Linux and in rare cases on Windows

1.2.0 - 15.02.2018

Log UART output to file in $HOME/.lobaro/

1.1.x

Restore Default Config
Close button
Closing the browser window now also shut down the server