- Press and hold button (1) for 2-3 seconds, until device start flashing led
- Wait, in case of successfull join, device will flash led 5 times
- If join failed, device will flash led 3 times
- Hold button (1) for 10 seconds, this will reset device to FN(factory new) status
- Go to step 1 for FN device
- Gerber, BOM, Scheme 2AAA
- Gerber, BOM, Scheme CR2
- Attention! Do not use CR2032 and CR2450 with a motion sensor (AM312 / BS312), as at low battery voltage (<3v) false alarms occur.
- Downalod from github releases
-
Settings can be changed without restarting zigbee2mqtt
-
Bind
- firmware github diyruz by @anonymass
- hardware and testing by @ring04
- telegram channel Zigdev