This is a handwired dactyl manufor utalising an RP2040-zero

• Keyboard Maintainer: Ethan
• Hardware Supported: Waveshare RP2040-Zero
• Hardware Availability: https://www.waveshare.com/wiki/RP2040-Zero
• 3D Print File Source: https://dactyl.mbugert.de/manuform

Make example for this keyboard (after setting up your build environment):

make handwired/alcor_dactyl:default

Flashing example for this keyboard:

make handwired/alcor_dactyl:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Enter the bootloader in 3 ways:

• Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
• Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
• Keycode in layout: Press the key mapped to QK_BOOT if it is available