#
# About
#
#  Show the binary opcodes of this program!
#
# Usage:
#
#  $ go.vm run ./quine.in
#
# Or compile, then execute:
#
#  $ go.vm compile ./quine.in
#  $ go.vm execute ./quine.raw
#

        #
        #  The number of bytes to show is the same as the length
        # of this (compiled) script.
        #
        #  If we store the offset of the "end" label, in register 1,
        # that will correspond to our length.
        #
        store #1, end

        #
        #  We'll loop with offset 1.
        #
        #  i.e. register 1 is the store of iterates.
        #
        #       and each loop we set: reg1 = reg1 - reg2
        #
        #
        store #2, 1

        #
        #  Address to show
        #
        store #3, 0

:repeat
        #
        #  Get the contents of the byte and show it
        #
        peek #5, #3
        print_int #5

        #
        #  Increase to show the next address.
        #
        inc #3

        #
        #  Show some spacing.
        #
        store #5, " "
        print_str #5

        #
        #  Loop until we're done.
        #
        sub #1, #1, #2
        jmpnz repeat

        #
        #  Terminate with a newline.
        #
        store #1, "\n"
        print_str #1
        exit

        #
        #  DATA - just for fun.
        #
        DB 0x01, 0x0F, 0x02, 0xF0
        DATA 255, 255

:end