You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
When you upload a protocol there are 2 tabs for what goes on your deck Robot Configuration and Labware. Robot Configuration shows what side to put pipettes on and modules should be put on the deck. But when you go to labware it does not show expected slots.
Current Behavior
Expected Behavior
On Labware tab show where each piece of labware is expected to be.
If there are multiple pieces of same labware, comma delimit all locations
Steps To Reproduce
No response
Operating system
Linux
Robot setup or anything else?
No response
The text was updated successfully, but these errors were encountered:
Overview
When you upload a protocol there are 2 tabs for what goes on your deck Robot Configuration and Labware. Robot Configuration shows what side to put pipettes on and modules should be put on the deck. But when you go to labware it does not show expected slots.
Current Behavior
Expected Behavior
On Labware tab show where each piece of labware is expected to be.
If there are multiple pieces of same labware, comma delimit all locations
Steps To Reproduce
No response
Operating system
Linux
Robot setup or anything else?
No response
The text was updated successfully, but these errors were encountered: