Skip to content

Latest commit

聽

History

History
53 lines (32 loc) 路 2.14 KB

ASSEMBLY.md

File metadata and controls

53 lines (32 loc) 路 2.14 KB
Raw

Sprig Assembly Guide

Contents

Parts of game console laid out on a wooden table

  • 1x Sprig PCB
  • 1x LCD screen
  • 2x spacers (for LCD screen)
  • 1x Raspberry Pi Pico
  • 4x backings (with D-pad cutouts)
  • 4x backings (flat)
  • 8x buttons
  • 2x M2*16 screws (for the LCD screen)
  • 8x M2*10 screws (for the backings)
  • 10x M2 Nuts
  • Allen key

Instructions

  1. Connect the LCD screen to the pins on the top of the board.

Photo of a PCB with LCD attached

  1. Add spacers and put screws through the holes.

Photo of an LCD assembled with screws and spacers

  1. Put buttons in corresponding holes on each side of the board.

Photo of a single button on a PCB

Photo of a PCB with an LCD and 8 buttons

  1. Turn the board over, and put the clear backings on. The first piece should have a D-pad cutout; the smooth piece should be on top. Make sure to peel of the protective plastic film on the front and back of each piece.

Photo of a protective plastic film being peeled off of an acrylic piece

Photo of a piece of plastic with a D-pad cutout on a PCB

Photo of two plastic pieces stacked atop a PCB

  1. Put screws in holes and add nuts on the top side of the board.

Four screws securing 2 pieces of plastic to a PCB

  1. Put in the Raspberry Pi Pico, with the USB port facing the outside edge of the board.

Photo of a PCB

  1. Put in 2 AAA batteries (not included).

Photo of an assembled handheld game console