Radio.Init() Changes LED Pixel Behavior

[Teku16]

Hello,

I am using a modified LoRa send code on an AB02S module, and when the following lines are used (required for our code), I lose all ability to control the pixel beyond the color green.

Radio.Init( &RadioEvents );
Radio.SetChannel( RF_FREQUENCY );
Radio.SetTxConfig( MODEM_LORA, TX_OUTPUT_POWER, 0, LORA_BANDWIDTH,
                                  LORA_SPREADING_FACTOR, LORA_CODINGRATE,
                                  LORA_PREAMBLE_LENGTH, LORA_FIX_LENGTH_PAYLOAD_ON,
                                  true, 0, 0, LORA_IQ_INVERSION_ON, 3000 );
Radio.SetSyncWord(0x13);

PlatformIO file:

[env:cubecell_gps]
platform = heltec-cubecell
board = cubecell_gps
framework = arduino
upload_port = COM5
upload_speed = 921600
monitor_port = COM5
monitor_speed = 115200

Libraries in use:

#include "LoRaWan_APP.h"
#include "Arduino.h"
#include "GPS_Air530Z.h"
#include "HT_SSD1306Wire.h"
#include "CubeCell_NeoPixel.h"

I don't think my code is relevant to the issue. I thoroughly tested via removing sections of my code, and the part above is what causes the LED to go only green, regardless of what I do (pixels.clear(), pixels.setPixelColor).

[Teku16]

I also tried using the built-in turnOnRGB(COLOR_SEND,0); //change rgb color RED and I got a lime color. Violet gets white, yellow gets green, blue gets aqua.. They are all green based. When I remove the Radio references, I have no issues getting full spectrum RGB from either method. I have tried this on multiple AB02S units.

[identeddie]

Did you find anything?