-
Notifications
You must be signed in to change notification settings - Fork 20
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
FNIRSI GC-01: Data communications #83
Comments
Thank you @Gissio I was looking for it under The port comes up, but it's a bit hit and miss, it's sometimes does, and other times you have to press more than once on the
Now, I can connect to it but device does not seem respond to any of the examples. [ using baud-rate 115200 and settings as advised] , any advice? |
It's a great idea to store the data mode state in the settings. Will be added in the next release. If you have trouble connecting, check the USB cable. To test, try https://github.com/Gissio/geigerlog-radpro. |
Good work! looks great ;) , Can the
Okay I think I found out more about "enable
Thanks for the heads up for the |
For a CLI interface, please read the manual: https://github.com/Gissio/radpro/blob/main/docs/users.md#radpro-tool. |
Installed Rad Pro on GC-01's with a CH32F103R8T6 processor (WCH)
radpro-fnirsi-gc01-ch32f103r8-2.0rc4.bin
.All work beautifully on the device, thank you! I would like to use the serial interface to read the data from the device but have some issues on Linux with enumerating the serial port over USB correctly.
Mass storage is enumerated correctly:
Is USB-C to serial bridge supported on GC-01 with WCH MCU?
The text was updated successfully, but these errors were encountered: