You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I'm using Ettus B205mini with Android phone. After programming FPGA and starting samples stream power consumption increasing. But when samples stream is stopped power consumption remains on the same level even though hardware not in use.
Expected Behavior
When board is not sampling to reduce power consumption.
Actual Behaviour
Power consumption remains the same as when board is receiving samples.
Steps to reproduce the problem
Connect Ettus board
Check power consumption
Start any GNURadio receive program.
Check that power consumption is increased.
Close GnuRadio
Check that power consumption is not decreased.
Additional Information
Is it possible to reduce power consumption without resetting FPGA program? Using libuhd or with hardware mod?
The text was updated successfully, but these errors were encountered:
Issue Description
Standby / Low power / Suspend mode
Setup Details
I'm using Ettus B205mini with Android phone. After programming FPGA and starting samples stream power consumption increasing. But when samples stream is stopped power consumption remains on the same level even though hardware not in use.
Expected Behavior
When board is not sampling to reduce power consumption.
Actual Behaviour
Power consumption remains the same as when board is receiving samples.
Steps to reproduce the problem
Additional Information
Is it possible to reduce power consumption without resetting FPGA program? Using libuhd or with hardware mod?
The text was updated successfully, but these errors were encountered: