my_setup.md

layout	title	nav_order
default	My Setup	11

{% comment %}

This page has moved! Please visit the new location.

{% endcomment %}

My Setup

Voron V2.4 350mm (with some V2.2 parts still on it)

• Toolhead
  • 📄 Stealthburner toolhead
  • 📄 Orbiter 1.5 extruder (LDO motor version) - mounted with 📄 this mod
  • Rapido UHF with Bondtech CHT Volcano 0.4mm nozzle
• Hardware Upgrades
  • 📄 Fabreeko HoneyBadger textured PEI
  • LDO-42STH40-2004MAH(VRN) A/B motors
    • Honestly I'd stick with the OMC motors from the sourcing guide. Didn't get much quality increase out of the upgrade to 0.9° motors, just lower speeds 🤡
  • Single Hiwin MGN9 rail on X
  • 📄 Genuine Gates brand pulleys/idlers in gantry
  • 📄 BTT Smart Filament Sensor
• Mods
  • 📄 Euclid (using Klicky macros) w/ 📄 auto z calibration
  • Chamber thermistor
  • 📄 Bed fans
  • Umbilical
    • i.e. "flappy cable". No X/Y cable chains.
    • This saves a fair bit of weight on the X axis, and I have not had a single wire break since (I had a lot of wire breaks with cable chains and got sick of them.) It's also WAY easier to service. You do lose a bit of Z height, though.
    • I just did this the janky way - I just wrapped the wires up and zip tied the far end to the Z chain, and the toolhead side to the reverse bowden tube. There are prettier mods out there for it.
  • Toolhead X endstop & 📄 relocated Y endstop
    • Allows for umbilical.
    • The Y endstop relocation is also available as part of the pin mod below.
    • The toolhead X endstop is my own mod, and is outdated now. Not sure what other options are currently available, haven't looked into it.
  • 📄 Pin mod
  • 📄 GE5C mod
  • Gantry backers
    • 📄 MGN9 Y backers
    • 📄 Titanium X backer
    • These prevent the gantry from 📄 warping with heat.
  • Frame thermistor
    • Used for sofware frame thermal expansion compensation (to combat thermal drift. Allows me to print from cold, without heat soaking. Though I do still wait for a minimum chamber temp to be reached.)
      • There are some more links about this in 📄 Thermal Drift.
  • 📄 Decontaminator nozzle brush
  • Voron V2.2 handles & single panel front door
  • PiCam with some random Thingiverse mount
  • 📄 Annex Engineering twist-lock panel clips