Print complete & change filament (M600) notification

[blonestar]

Can someone point me where to read how to setup to get notification on print complete and for example on change filament with gcode (macro M600).
Thank you

# I tried this for print complete
[progress_notification]
percent: 100

######################################################################
# Filament Change
######################################################################

# M600: Filament Change. This macro will pause the printer, move the
# tool to the change position, and retract the filament 50mm. Adjust
# the retraction settings for your own extruder. After filament has
# been changed, the print can be resumed from its previous position
# with the "RESUME" gcode.

[pause_resume]

[gcode_macro M600]
gcode:
    {% set X = params.X|default(50)|float %}
    {% set Y = params.Y|default(0)|float %}
    {% set Z = params.Z|default(10)|float %}
    SAVE_GCODE_STATE NAME=M600_state
    PAUSE
    G91
    G1 E-.8 F2700
    G1 Z{Z}
    G90
    G1 X{X} Y{Y} F3000
    G91
    G1 E-50 F1000
    RESTORE_GCODE_STATE NAME=M600_state

[blonestar]

This doesn't work for me either. Command has been executed without error but no message in Telegram.

[blonestar]

Bot is configured and working, I would say normally. Secrets are moved to secrets.conf
So that is not an issue, and I need a hint. :)

[nlef]

This doesn't work for me either. Command has been executed without error but no message in Telegram.

Extra symbol ':' must be removed. Prefix must be 'telegram'.

[blonestar]

Thanks but it's not working, just tested. Restarted everything, command sent but Telegram is quiet.

[blonestar]

Oh, I figure out...
It should be 'tgnotify' instead of 'telegram'.

RESPOND PREFIX=tgnotify MSG="Test message"

[blonestar]

Still not sure how to send message on printing job complete.

[aka13-404]

How do you do anything when your print is complete? You add a specific gcode or instruction to your "end gcode" in your slicer...

[blonestar]

I'm new to 3d printing, gcode and Klipper. Forgive me. :)
But understand now, will probably add end gcode to my Klipper printer config, thank you very much.

[aka13-404]

If it helps, the bot is rather an executing organ in this whole ecosystem. It rarely does stuff on its own, on purpose. The general idea is that you instruct it to do something, when you need it. This "when" is rarely easily detectable without some external variable, or withour straight injection from the gcode being printed.

[blonestar]

Yep, getting the picture day by day. :)
And btw it works flawlessly, thank you for the great work!